With the development of science and technology, higher and newer requirements have been put forward for optical fiber. Below we introduce the implementation of indoor optical cable wiring related issues.

 

Generally, we will encounter the laying of indoor optical cable in the general wiring. The laying of indoor optical cable is mainly applied to the laying of horizontal subsystem and vertical backbone subsystem. The laying of the horizontal subsystem optical cable is very similar to that of the twisted cable. Only because the cable has worse tensile strength, it should be more careful in traction and the radius of curvature should be larger. The optical cable of vertical main subsystem is used to connect the equipment to the distribution line of each floor.

 

Two core 8 cable

 

To prevent sagging or slipping down, cables must be firmly anchored on the runways, lower ends and centers of each floor. In general, nylon straps or steel clips can be used for useful fixation. After all, oil and linen sealing materials are also used to block and seal all the slot holes and openings of pipe holes through optical cables in all floors of the building.

 

When laying optical cable, appropriate length should be reserved according to the planning requirements. Generally, 5-10m should be reserved at the equipment end.

 

Ribbon flat cable

 

Above is the small editor about indoor optical cable wiring related issues.